HP StorageWorks 1000i Virtual Library System - Manual (Page 26)

10685A
Figure 6 Remove slides from rails
Attach rails to the VLS1000i (appliance)
2
1
2
1
5202
Figure 7 Attach slides to appliance
1.
Attach the two bezel brackets to the appliance using the supplied bracket screws, as shown (1).
2. Attach an inner slide rail (lock facing out) to each side of the appliance. Insert the slide rail screws
through the inner slide rails as shown (2), and then tighten.
Install appliance in rack
1. Extend the outer slide rails fully from the rack until they lock. Insert the inner slide rails into the
outer slide rails as shown (1). Press the inner slide lock (2), and then push the appliance all the
way into the rack.
26 Setting up the VLS1000i hardware