Allied Telesis AT-S81 User Manual
Page 107
AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface
107
6. To add ports to the VLAN, do the following:
a. Type S to select Select Port Number.
The following prompt is displayed:
Enter port number >
b. Enter the ports of the VLAN.
You can specify the ports individually separated by commas, for
example, 2,7,15, as a range of ports separated by a hyphen, for
example, 2-4, or both, for example, 2-7,15,17.
7. When the VLAN is complete, type A to select Apply and apply the
VLAN settings.
The VLAN Management Menu is displayed again with information
about the VLAN you just created. The VLAN is now active on the
switch.
8. If you intend to define a port as an untagged member of a VLAN, you
will need to change the PVID of the port to match the VLAN’s VID.
Refer to “Configuring the Port PVID” on page 108.