Allied Telesis AT-S81 - Manual (Page 201)

AT-S81 Management Software User’s Guide
Section II: Web Browser Interface 201
The range is 0 to 60 minutes. The default is 5 minutes. A timeout
value of 0 causes the console connection to never times out.
The console idle time out parameter specifies the length of time a
local management session can be inactive before the management
software automatically ends it. The purpose of this parameter is to
prevent unauthorized individuals from configuring the switch should
you leave your management workstation unattended.
This parameter applies to a local management session but not to a
web management session. A web browser management session
remains active so long as your web browser is open.
Note
If you select 0, you must remember to properly log off from a local
management session when you are finished to prevent blocking
future management sessions with the switch.
b. Click Apply.
4. To configure the Telnet UI timeout value, do the following:
a. In the Telnet UI Time Out field, enter a new value.
The Telnet idle time out parameter specifies the length of time that
a remote Telnet management session can be inactive before the
management software automatically ends it.
5. To change the user settings, do the following:
a. Enter the existing name and password in the User Name and
Password fields. The default name and password are both
“manager”. The login name and password are case sensitive.
b. Click the New User Name field and enter a new user name or, if
you do not want to change the login name, enter the current name.
Leaving this field empty deletes the current login name without
assigning a new one. The name can be from 0 to 12 characters.
Spaces are allowed. The login name is case sensitive.
c. Click the New Password field and enter a new login password or,
if you do not want to change the password, enter the current
password. The password can be from 0 to 12 characters. Allied
Telesyn recommends not using special characters, such as spaces
and exclamation points. The password is case sensitive. Leaving
this field empty deletes the current password without assigning a
new one.
d. Click the Verify New Password field and enter the same
password entered in the previous step.