Allied Telesis AT-S81 - Manual (Page 153)

AT-S81 Management Software User’s Guide
Section II: Menus Interface 153
Select port number to be changed>
Port number is in range from 1 to 9, 0 to set all ports
This parameter enables or disables RSTP on a specified port or a
group of ports in a trunk.
11. Enter the number of the port you want to change, or type 0 (zero) to
apply the settings to all ports on the switch.
The following prompt is displayed:
Enable or Disable STP for port n (E/D)>
12. Type E to enable or D to disable STP on the port.
Configuring the
Advanced RSTP
Port Settings
To configure the advanced RSTP port settings, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type S to select Rapid
Spanning Tree Configuration.
The Rapid Spanning Tree Configuration Menu is shown in Figure 34
on page 145.
3. From the Rapid Spanning Tree Configuration Menu, type A to select
RSTP Advanced Port Configuration.