Configuring rstp port settings, Configuring the basic rstp port settings – Allied Telesis AT-S81 User Manual
Page 265
AT-S81 Management Software User’s Guide
Section II: Web Browser Interface
265
Configuring RSTP Port Settings
This section contains the following topics:
“Configuring the Basic RSTP Port Settings,” next
“Configuring the Advanced RSTP Port Settings” on page 266
Configuring the
Basic RSTP Port
Settings
To configure the basic RSTP port settings, perform the following
procedure:
1. From the Basic Config menu, select Rapid Spanning Tree and then
RSTP Basic Port Config.
The RSTP Basic Port Configuration page is shown in Figure 72.
Figure 72. RSTP Basic Port Configuration Page
2. In the STP Status column for the port you want to configure, select the
STP status from the list, either Enable or Disable.
3. In the Priority column for the port you want to configure, type a number
for the port priority.
Port priority is described in “Port Priority” on page 140.
4. In the Path Cost column for the port you want to configure, type a
number for the Path Cost.