Allied Telesis AT-S81 User Manual
Page 125
AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface
125
The Port Priority Configuration Menu is shown in Figure 26.
Figure 26. Port Priority Configuration Menu
The columns in the menu display the following information:
Port
Displays the port number.
Trunk
Displays the trunk number if the port is a member of a trunk.
Traffic Class
The traffic class currently associated with the port.
Queue
Displays the number of the queue where untagged packets received
on the port are stored on the egress queue.
Override
Displays whether the priority level in ingress tagged frames is being
used or not. If No, the override is disabled and the port is using the
priority levels contained within the frames to determine the egress
queue. If Yes, the override is enabled and the tagged packets are
stored in the egress queue specified in the Queue column.
4. To configure a port that is not a member of a trunk, type R to select Set
Traffic Class. To configure the ports of a port trunk, type T to select
Set Trunk Traffic Class.
AT-8000/8POE Local Management System
Quality of Service Configuration -> Port Priority Configuration Menu
Port
Trunk
Traffic Class
Queue
Override
----
-----
-------------
-----
--------
1
---
0
0
Disabled
2
---
0
0
Disabled
3
---
0
0
Disabled
4
---
0
0
Disabled
5
---
0
0
Disabled
6
---
0
0
Disabled
7
---
0
0
Disabled
8
---
0
0
Disabled
9
---
0
0
Disabled
3 : Highest
0 : Lowest
----------------------- <COMMAND> -----------------------------------------
Set T[r]affic Class
Set [T]runk Traffic Class
[Q]uit to previous menu
Set [O]verride Status
Set Trun[k] Override Status
Command>