Allied Telesis AT-S81 - Manual (Page 91)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 91
Configuring PoE
This section contains the following procedures:
ˆ “Displaying the PoE Configuration,” next
ˆ “Changing the PoE Port’s Admin Setting” on page 92
ˆ “Setting the PoE Port’s Priority” on page 93
Displaying the
PoE
Configuration
To display the current PoE Configuration, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 15 on
page 75.
2. From the Advanced Switch Configuration menu, type E to select
Power Over Ethernet.
The Power Over Ethernet menu is shown in Figure 18.
Figure 18. Power Over Ethernet Menu
AT-8000/8POE Local Management System
Advanced Switch Configuration -> Power Over Ethernet Menu
Power Budget : 95W
Power Consumption : 40W
NO. Admin Status Class Priority Pow.(mW) Vol.(V) Cur.(mA)
--- ----- -------------- ----- -------- -------- ------- --------
1 Up Powered 0 High 7109 69 103
2 Up Not Powered 0 Low 0 0 0
3 Down Not Powered 0 Low 0 0 0
4 Up Not Powered 0 Low 0 0 0
5 Up Powered 0 Critical 2006 0 0
6 Up Not Powered 0 Low 0 0 0
7 Up Not Powered 0 Low 0 0 0
8 Up Not Powered 0 Low 0 0 0
-----------------------------<COMMAND>-----------------------------------
Set PoE Port Admin [S]tatus
Set PoE Port Pr[i]ority
[Q]uit to previous menu
Command>