Allied Telesis AT-S81 - Manual (Page 66)

Chapter 5: SNMP
66 Section I: Using the Menus Interface
Enabling or Disabling the SNMP Agent
To disable or enable the SNMP agent, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type U to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
38.
3. From the User Interface Configuration Menu, type S to select Enable/
Disable SNMP Agent.
The following prompt is displayed:
Enable or Disable SNMP agent (E/D)>
4. Type D to disable the SNMP agent or E to enable it. The default is
Enabled.