Resetting to the default vlan – Allied Telesis AT-S81 User Manual
Page 115
AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface
115
Resetting to the Default VLAN
The following procedure for deletes all VLANs, except the Default_VLAN,
on a switch. To delete selected VLANs, refer to “Deleting a VLAN” on
page 114.
To reset to the default VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 15 on
page 75.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 21 on page 105.
3. Type R to select Reset VLAN to Default.
The following prompt is displayed:
Are you sure to reset VLAN configuration to factory
default (Y/N)>
4. Type Y for Yes.
The following prompt is displayed:
Reset to factory default completed, press any key to
continue.
5. Press any key.