Changing the default snmp community names – Allied Telesis AT-S81 User Manual
Page 68
Chapter 5: SNMP
68
Section I: Using the Menus Interface
Changing the Default SNMP Community Names
To change the names of the default SNMP communities, perform the
following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 14 on page 67.
3. Type R to select Set SNMP Read Community.
The following prompt is displayed:
Enter read community name>
4. Type the name of the read community. The default is “public.”
5. Type W to select Set SNMP Write Community.
The following prompt is displayed:
Enter write community name>
6. Type the name of the write community. The default is “private.”