Displaying the port parameters – Allied Telesis AT-S81 User Manual
Page 56
Chapter 4: Port Configuration
56
Section I: Using the Menus Interface
Displaying the Port Parameters
To display the parameter settings for the ports on the switch, perform the
following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type P to select Port
Configuration.
The Port Configuration Menu is shown in Figure 13.
Figure 13. Port Configuration Menu
AT-8000/8POE Local Management System
Basic Switch Configuration -> Port Configuration Menu
Port
Trunk
Type
Link
Status
Mode
Flow Ctrl
----
-----
------
----
------
------------
---------
1
---
10/100TX
Up
Enabled
Auto
(100F)
Enabled
2
---
10/100TX
Up
Enabled
Auto
(100F)
Enabled
3
---
10/100TX
Up
Enabled
10-FDx
Enabled
4
---
10/100TX
Up
Enabled
Auto
(100F)
Enabled
5
---
10/100TX
Up
Enabled
Auto
(100F)
Enabled
6
---
10/100TX
Down
Enabled
100-HDx
Enabled
7
---
10/100TX
Up
Enabled
Auto
(100F)
Enabled
8
---
10/100TX
Down
Enabled
Auto
Enabled
9
---
1000X
Up
Enabled
Auto
(1000F)
Enabled
----------------------- <COMMAND> ------------------------------------
Set [S]tatus
Set [F]low Control
Set [M]ode
[Q]uit to previous menu
Command>