Sony LF-X11 - Manual (Page 17)

F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB05C01-WW.fm masterpage: Right
LocationFreeTV
2-655-608-11(1)
Pr
e
p
ar
at
ions
17
Attach the supplied IR Blaster to the device
connected to the Base Station.
By attaching the IR Blaster, you can control the
connected device with the on-screen remote
control.
To locate the infrared receiver, refer to the
operating instructions for the connected device.
Be sure to place the IR Blaster above the infrared
receiver.
Note
Do not remove the backing paper from the IR Blaster
yet.
After confirming that the remote control works
correctly, remove the backing paper from the rear
side of the IR Blaster and then secure the IR
Blaster in place.
When controlling two devices with the IR
Blaster, position the devices and the IR Blaster as
shown.
Note
For details on setting up a device, refer to the operating
instructions of the device.
If the infrared receivers on two devices do not line
up and cannot be controlled with the single
supplied IR Blaster, you need to purchase a plug
adapter (not supplied) and another IR Blaster.
Connect the plug adapter to the IR BLASTER
port on the Base Station and connect each IR
Blaster to a port on the adapter plug.
See “Configuring the On-Screen Remote”
(
1 page 67) for information about how to switch
the on-screen remote for two devices to a single
input terminal.
z Tips
• If the IR Blaster cable is too short, use the extension
cable (RK-G138, not supplied).
• Infrared receivers on Sony VCRs and other products
are identified with the symbol.
• You can set up 2 on-screen remote controls for each
video input connector. These on-screen remote
controls allow you to operate 2 devices connected
directly to the Base Station, and to control video
input via those devices.
Connecting the IR Blaster
IR Blaster
Infrared transmitter
Infrared receiver
Backing paper
IR Blaster
Infrared receivers