Sony LF-X11 User Manual
Page 76
F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB09C05-WW.fm
masterpage: Left
LocationFreeTV
2-655-608-11(1)
76
3
The current automatic router
configuration (UPnP) status appears
here.
Note
If you changed the setting of step 2, then to
update the automatic router configuration (UPnP)
status of step 3 you need to select [OK] in step
4
and then display the [Port Number for NetAV]
window again.
4
Select [OK].
You return to the [NetAV Settings] window.
Make a note of the port number set in step
1
. If the port number was changed, you will
need it when you carry out the procedure in
“Setting up the Monitor” (
5
Select [Back].
You return to the [Base Station] window.
6
Select [Settings], and then select [Exit].
This completes the preparations you need
before leaving home. The following
describes settings while on the go.
7
Configure port forwarding for the router.
Enter the IP address of the Base Station that
you set in “Configuring the LAN Settings
Required for Port Forwarding” (
and the port number that you set in “Setting
up NetAV on the Base Station”
(
1 page 75). For details, refer to the
operating instructions for your router.
Setting up the Monitor
Proceed as follows to set up the Monitor so that it
can receive video from the Base Station while
you are on the go.
Normally these settings are not required when
you have performed [Easy Setup (NetAV)].
If you changed the port number of the Base
Station, also configure the same setting on the
Monitor.
1
Open the [Settings] window, and then select
[Monitor].
The [Monitor] window appears.
2
Select [NetAV Settings].
The [NetAV Settings] window appears.
3
Select [NetAV Connection].
The [NetAV Connection] window appears.
4
Set the items in the window, and then select
[OK].
1
Enter the domain name that you
registered when you applied for your
Dynamic DNS service, or a Domain
name in the format
[example.dns.lflinkup.com]. Do not
prefix it with [http://].
If you are using a static global IP address
service, enter the static global IP address.
2
Enter the port number that you set in
“Setting up NetAV on the Base Station”
(
3
Select [OK].
You return to the [NetAV Settings] window.
5
Select [Back].
You return to the [Monitor] window.
6
Select [Settings], and then select [Exit].