Sony LF-X11 - Manual (Page 78)

F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB09C05-WW.fm masterpage: Left
LocationFreeTV
2-655-608-11(1)
78
1 Select [Start].
2 Check if you want to give priority to
NetAV connections by registered
LocationFree devices when you are
watching TV or video on the Monitor in
Home mode.
When checked, no TV or video will
appear on the Monitor while the other
device is connecting NetAV. However,
you can set [GetAV] with the Monitor in
Home mode to interrupt the NetAV
connection and display TV and video on
the Monitor again.
When you select [Start], the current status
changes from [Registration not accepted] to
[Ready for registration], and an 8-character
password appears in [Password]. You will
need this password when you register
Location Free device.
z Tips
• If the registration of the LocationFree device
( 1 page 78) succeeds, then the information
for the LocationFree device will appear in
[Registered Devices]. If the LocationFree
device does not appear in the [Registered
Device] list, select [Refresh] to update the list.
• To exit the [Ready for registration] mode,
select [Stop].
• The registration password changes with every
registration. If you exit the [Ready for
registration] mode, and then start another
registration, the registration password changes
to a new password.
• If you want to stop connecting to the Base
Station from a registered Monitor, place a
check by the Monitor in the registered device
list and then select [Delete].
5
Select [Back].
You return to the [NetAV Settings] window.
6
Select [Settings], and then select [Exit].
Next proceed to the steps in “Configuring
Additional Monitor Settings” (see right).
To continue by registering a computer with the
Base Station over the Internet, refer to the LF-
PK1 Operating Instructions. To register a LF-X11
Monitor, proceed to “Configuring Additional
Monitor Settings” (
1 page 78).
z Tip
To register a LF-X1/X5 Monitor, refer to the LF-X1/
X5 Operating Instructions.
Note
Do not turn the Base Station power off.
Put Base Station into a mode where it can accept
Device Registration, and then proceed as follows
to register another Monitor. Operate the Monitor
to make the following settings. When you make
these settings, the Monitor must be connected to
the Internet in On the Go.
1
Open the [Settings] window, and then select
[Monitor].
The [Monitor] window appears.
2
Put the Monitor into On the Go, and then
connect to the Internet.
Note
If you switch to On the Go-Wireless, you will
need to be connected to a public wireless LAN
until the point when you select [Start] in step 7.
See “Configuring a Public Wireless LAN
Connection Manually” (
1 page 40) for more
information about connecting via public wireless
LANs.
3
Select [NetAV Settings].
The [NetAV Settings] window appears.
4
Select [NetAV Connection].
The [NetAV Connection] window appears.
Configuring Additional
Monitor Settings