Sony LF-X11 - Manual (Page 64)

F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB09C05-WW.fm masterpage: Left
LocationFreeTV
2-655-608-11(1)
64
Using another wireless device
nearby
If you are using two or more Base Stations within
close range, or using your Base Station in range
of a 2.4 GHz or 5 GHz wireless access point that
conforms to IEEE802.11a, b, or g standards, the
wireless signal from the Base Station to the
Monitor may be disrupted. In this case, set your
Base Station to [Automatic: 2.4GHz & 5GHz],
[Automatic: 2.4 GHz only] or [Automatic: 5 GHz
only] in the [Home Wireless (Wireless Channel)]
window, and then set the wireless access point to
a fixed channel. If images still do not display
properly on the Monitor, select [Manual] in the
[Home Wireless (Wireless Channel)] window
and manually change to a different channel than
that set for the wireless access point.
Note
The term “wireless access point” above does not refer
to the wireless transmission function of the Base
Station, but to a separate wireless transmission device.
The Monitor is set to wireless connection
whenever it is not capable of communicating over
the wired LAN, for example when you have
disconnected the LAN cable (not supplied). In
this state, a wireless signal is emitted. In places
where wireless emissions are restricted, disable
wireless on the Monitor.
1
Open the [Settings] window, and then select
[Other].
The [Other] window appears.
2
Select [Wireless OFF].
The [Wireless OFF] window appears.
3
Check the [Disable Monitor’s Wireless
Emission] check box, and then select [OK].
A confirmation message appears.
4
Select [OK].
The Monitor’s power is turned off, and then
on again automatically.
Note
If wireless is disabled, the Monitor cannot connect
wirelessly to the Base Station or a public wireless
access point.
Stopping Wireless
Signal Emissions
From the Monitor
Check
this.