Sony LF-X11 - Manual (Page 67)

F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB09C05-WW.fm masterpage: Right
LocationFreeTV
2-655-608-11(1)
O
th
e
r Fun
ctio
ns a
nd Se
ttings
67
If you have connected a cable box (STB) to the
VHF/UHF terminal on the Base Station, you can
configure the on-screen remote control to show
the STB remote control.
z Tip
Before carrying out the following steps, you must
install the IR Blaster so that it points to the IR receiver
of the STB remote control.
1
Open the [Settings] window, and then select
[TV/Video].
The [TV/Video] window appears.
2
Select [Remote Settings].
The [Remote Settings] window appears.
3
Select [TV].
The [TV] window appears.
4
Select [External TV tuner (e.g. STB)], and
then select the make and type of the STB.
A list of types appears when you select
[External TV tuner (e.g. STB)].
When the device is configured correctly, you
can turn it on and off by selecting [Power].
Use the sub-screen to confirm that the power
turns on and off.
If selecting [Power] several times does not
turn on and off the connected device, make
sure the make and type you have selected are
correct.
z Tip
Select [Learning] to change the configuration of
the remote control buttons with the learn
function. For details, see “Learning Commands
for On-Screen Remote” (
1 page 69).
5
Select [Back].
You return to the [Remote Settings] window.
6
Select [Settings], and then select [Exit].
Use the following procedure to change the
configuration of a remote control for the device
that you have connected to a video input.
1
Open the [Remote Settings] window, and
then select [Video 1] or [Video 2].
Select the video input to which the device is
connected.
The [Video 1] or [Video 2] window appears.
Configuring the On-
Screen Remote
Configuring the On-Screen
Remote for External Tuners
on TV
Configuring the Remote
Control for External Devices
Continued