Sony LF-X11 - Manual (Page 89)

F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB10C06-WW.fm masterpage: Right
LocationFreeTV
2-655-608-11(1)
Oth
e
rs
89
TV
No picture
No picture
(Continued) • Home-Wired LAN mode
• Check whether is visible at the top of the screen.
If it is not visible, check the following.
- Make sure that the LAN cable (not supplied) is securely connected
on the Monitor side.
- Check that the Wired LAN Home mode setup is correct ([Settings]
- [Monitor] - [Home]).
• If is visible, check the following.
- Check that the IP address of the Base Station is set correctly
([Settings] > [Monitor] > [Settings] next to Home-Wired LAN)
(
1 page 63).
• LAN connections which use PPPoE are not supported.
Picture freezes frequently. Home-Wireless mode
• Interrupted communications may be occurring. Try bringing the
Monitor closer to the Base Station, or use the Wide Rage Mode.
• The picture may freeze if another device is communicating nearby on
the same band as the Base Station. Change the band used by the Base
Station, or move farther away from the device that is causing the
interference.
Home-Wired LAN mode
• If the problem occurs on your home LAN, make sure that you are not
using a 10BASE-T router or hub.
Use a 10/100BASE-T router or hub.
“Interference/Wireless Out of Range”
appears on the screen. • Wait a short while.
• Bring the Monitor closer to the Base Station.
• Use the Wide Rage Mode.
• Try changing the wireless channel (
1 page 63).
Pictures appear to be grainy and
pixilated. • This happens because of image processing, and is not a malfunction.
The [Wide Range] button does not
appear. • Go to [Settings] - [Monitor] and make sure Home mode has been
selected. Also, if a LAN cable (not supplied) is connected, disconnect it
from the Monitor.
• Another Monitor or computer registered with the Base Station may be
using NetAV.
Select the [GetAV] button at the bottom of the screen. (This causes the
[Wide Range] button to appear.)
Problem Causes and remedies
Cannot get any TV channels to appear.
(screen is black). • Make sure the Base Station is turned on.
Cannot get any TV channels to appear.
(screen is filled with snow). • Check that [CABLE] is set to the right setting ([ON] or [OFF]), and
then run automatic channel scan again.
• Connect the antenna cable (not supplied) and CATV cable securely to
the Base Station ( 1 page 15).
• Make sure the STB is set correctly. Also confirm the specifications.
Cannot get some specific TV channels
to appear. Change the channel setting and adjust the reception frequency
(
1 page 65).
Problem Causes and remedies
Continued