Tv and video – Sony LF-X11 User Manual
Page 88
F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB10C06-WW.fm
masterpage: Left
LocationFreeTV
2-655-608-11(1)
88
TV and video
* appears. (Continued)
* This icon only appears in Home mode.
Home-Wired mode
• Check that the Monitor and Base Station are located on the same
network.
• If that does not solve the problem, select [Settings] > [Monitor] >
[Settings] next to Home-Wired LAN > [Base Station Address], and
check that the IP address shown on the screen matches the IP address of
the Base Station. You can check the Base Station’s IP address with
[Settings] > [Base Station] > [Internet Connection].
Screen suddenly goes dark.
With the Web Lite, Mail, Album, or Settings window displayed, the power
save timer activated and turned off the backlight of the screen. Touch the
screen or press any button to illuminate the screen. If you prefer,
deactivate the power save timer (
Screen is too dark.
Adjust the Backlight in the settings window.
On-screen buttons do not respond.
• When the [Index] window or a dialog message is displayed, you cannot
select any button outside of that window or message.
• Dimmed buttons cannot be selected. Some buttons can only be selected
after selecting a check box.
A different button than the one you
selected responds.
The screen is not aligned with the stylus. See “Stylus Calibration”
(
Password error occurs.
Make sure you have correctly entered all upper and lower case letters. The
password field differentiates between upper and lower case.
Problem
Causes and remedies
No color or incorrect color
• Adjust the picture quality (
• Verify whether the AV cable is correctly connected.
Picture appears, but no sound.
• Make sure the volume is not turned down all the way.
• Make sure there are no headphones connected.
No picture
• Make sure the Base Station is turned on.
• Make sure the correct connection mode is selected ([Settings] -
[Monitor]).
• If the SETUP MODE LED of the Base Station is flashing or lit, wait
until Setup mode ends or turn the Base Station off and then on.
• Check whether
is visible at the top of the screen.
appears at the top of the screen, and no picture appears, when
another registered device is using NetAV. A picture will appear if you
select [GetAV] at the bottom of the screen.
• Home-Wireless mode
• Check whether wireless communications have been interrupted.
Bring the Monitor closer to the Base Station, until
appears,
and check to be sure that the Base Station power is turned on.
• Check whether there is another device operating nearby on the same
wireless band (2.4 GHz/5 GHz) as the Base Station, for example
another wireless access point.
Problem
Causes and remedies