Sony LF-X11 User Manual
Page 75
F:\M_K\SONY\5051480_LF-
X11_OI\2655608111\2655608111\2655608111_LF-X11\00GB09C05-WW.fm
masterpage: Right
LocationFreeTV
2-655-608-11(1)
O
th
e
r Fun
ctio
ns a
nd Se
ttings
75
*1 This sample input is when the router’s IP address is
192.168.0.1.
If the router’s IP address is 192.168.1.1, enter
192.168.1.64 for the IP address. Furthermore, if
you are using multiple Base Stations, set a different
setting for each Base Station, such as 64 and 65.
Set this to the port forwarding IP address that you
assigned to the Base Station on the router
(
*2 This sample input is when the router’s IP address is
192.168.0.1.
If the router’s IP address is 192.168.1.1, enter
192.168.1.1 for the default gateway and DNS 1.
You return to the [Internet Connection]
window.
4
Select [Back].
You return to the [Base Station] window.
5
Select [Settings], and then select [Exit].
6
Connect to the Internet to check whether the
LAN connection is set up correctly.
You can do this by checking whether web
pages appear (
Setting up NetAV on the Base
Station
Normally these settings are not required when
you have performed [Easy Setup (NetAV)].
If the router you are using is not compatible with
UPnP, disable UPnP. Also perform the following
procedure to configure the port number if it needs
to be changed.
1
Open the [Settings] window, and then select
[Base Station].
The [Base Station] window appears.
2
Select [NetAV Settings].
The [NetAV Settings] window appears.
[NetAV Settings] can be selected when the
Monitor is in Home mode.
If you cannot select [NetAV Settings], switch
to Home mode in the [Monitor] window.
3
Select [Port Number for NetAV].
The [Port Number for NetAV] window
appears.
4
Set the items in the window, and then select
[OK].
1
Change the NetAV server port number, as
required.
If there are multiple Base Stations and
5021 is already being used, change the
port number of the NetAV server so that
the number will not duplicate.
You can specify port numbers in the
range 5021 to 5999. At the time of
purchase, the port number is set to 5021.
2
Select [Disable] for [Automatic Router
Configuration (UPnP)].
When your router is compatible with
UPnP, you can use UPnP to configure
port forwarding on the router
dynamically. You do not need to make
manual port forwarding settings on the
router side if the router is compatible
with UPnP.
Setting item
Sample input value
(when the router’s IP
address is
192.168.0.1)
IP address
192.168.0.64
*1
Subnet mask
255.255.255.0
Default gateway
192.168.0.1
*2
Host name
Blank
DNS1
192.168.0.1
*2
DNS2
Blank
Continued