Festo Линейные модули HMP - Manual (Page 34)

HMP−...−B−...
Festo HMP−...−B−... 0408NH English
34
5 Fitting
Fitting mechanical components
S Avoid damaging the guide tube.
Damage will impair operational safety
and reliable functioning and reduce the
service life of the product.
S Make sure that the device is fitted free of
distortion and bending.
S Place the linear module type HMP−...−B
so that all operating parts are accessible.
S Select one of the fastening possibilities
listed in the following table:
Direct fastening
on ground surface
(only
HMP−16/20−...) Sliding block fastening on the side /
on ground surface (only HMP−25/32−...) Dovetail fastening
on the side /
on ground surface
Fig. 8
Further mounting possibilities can be found in the Festo catalogue or on the
Festo Internet page and the necessary accessories can be found in the chapter
Accessories (Internet address see last page of these operating instructions).
Fig. 6
Fig. 7