RADWAG TMX 6/15/H2 Multifunctional Scales - Manual (Page 121)

34.1.4. The way of installing inside PUE 5
Module is designated for assembly inside terminal PUE5. Module with
address 1 is assembled to main board of terminal to J13(Slot 0), module
with address 2 is assembled to connector J11 (Slot 1). For the second
module MW-02 gland is installed on casing lid, 3m cable ended with
insulated conductors is led through gland.
Installing procedure:
1. Unplug the terminal (remove the plug from socket 230V);
2. Unscrew the casing lid (back part of terminal casing);
3. Install the module in connector J13 or J11 on main board, depending on
it’s address ;
Installation of the module MW-02 on the motherboard terminal PUE 5
- 121 -