Hand operated tare value entering, Zeroing of scale, Eroing of scale – RADWAG TMX 6/15/H2 Multifunctional Scales User Manual
Page 14: Weighing on two range scales
After unloading product and packing from the pan the display shows the
tarred value with “minus” sign:
Notice:
Tarring process cannot be performed while the display shows a negative
or zero value. Then Err3 will appear on weighing window display.
10.2. Hand operated tare value entering
It is also possible to enter a tare value by hand.
Procedure:
- 14 -
• While in main window press
,
and you will see the following window:
• Using number buttons enter the required value
and accept it by clicking
,
• The scale returns to weighing mode.
The inscribed value will be preceded by „–”,
• Tarring can be applied at any time during weighing.
• Use
button
to remove the previous
value.
10.3. Zeroing of scale
Press
in program’s weighing window to get zero indication.
Symbols:
and
will appear.
Zeroing is equivalent to setting a new zero point interpreted by the scale
as the precise zero point. Zeroing can be performed only when display
is stable.