RADWAG TMX 6/15/H2 Multifunctional Scales - Manual (Page 127)

34.4. Analogue output module AN series
Module of analogue outputs
Module accessible in three configurations:
• Voltage output AN 0-10V
• Current output AN 4-20mA
• Current output AN 0-20mA
34.4.1. Technical specification
Work modes 4 - 20mA , 0 - 20mA, 0 - 10V
Resolution 16 bit
Current output resistance <500
Voltage output resistance >400
Power supply 24V DC (12 - 30V DC) max 40mA
34.4.2. The way of installing inside PUE 5
These modules are intended to mount inside PUE 5. They need to be
connected to the 10-pin J22 connector. For all configurations of AN, there
is a gland installed on the back wall of the housing. A 3-meter shielded
cables are led out via the gland. Wires should be free from insulation.
Installing procedure:
1. Unplug the terminal from mains;
2. Unscrew and take off the back wall of the housing;
3. Install your module in J22 on the main board;
- 127 -