Document Outline

• Table of Contents
• 1. INTRODUCTION
  • FCC PRECAUTIONS
• 2. INSTALLATION
  • TOOLS AND TEST EQUIPMENT
  • CROSS-CONNECT EQUIPMENT DESCRIPTION
    • Trunk Access Equipment
      • 700A- 110-M-25 or 700A-66-B1-25 (157BF) Cut-Down Jack
      • 10B Emergency Transfer Unit (ETU)
    • Station Interconnect Panel (SIP)
      • 617A Panel
      • Adapters
      • Fanning Strip
    • Cables
      • Splitter Cables
      • Octopus Cables
      • 8536 Adapter Cable
      • DS1 Connector Cables
      • Cable Labels
    • Symbols Used in Figures
  • PREINSTALLATION REQUIREMENTS
    • Table and Backboard
    • Network Interface
    • AC Power
    • Grounding
    • Lightning Protection
    • Secondary Protection
    • Building Wiring
  • INSTALL SYSTEM CABINETS
    • Position Cabinet(s)
    • Check Cabinet Contents
    • Required Circuit Pack Positions
    • Label Connectors on Back Cover
    • Install 4A Retainer Clips
    • Connect Cabinets
      • TDM Bus Connections
      • Ground Wire Connections
  • POWER UP AND INITIALIZE SYSTEM
    • Connect Power
    • Connect Administration Equipment
    • Cold Start the System
    • Check Performance of Cabinet Components
    • Report Problems
    • Initialize System
  • INSTALL CROSS-CONNECT EQUIPMENT
    • Install TAE, 617A Panels, and Fanning Strips
    • Mount 858A or 2210A2 Adapters
  • INSTALL MODULAR BULK POWER SUPPLY (Optimal)
  • INSTALL EQUIPMENT ROOM TRUNK CABLING
    • Connect Network Interfaces to TAE Blocks
    • Connect Cabinets to TAE Blocks
      • Connect Ground Start, Loop Start, and DID Trunks
      • Connect Tie Trunks
    • Install DS1
      • Connect S25 to Another On Premises PBX
      • Off Premises Metallic (Cable) Connections
      • Off Premises Non Metallic Connections
      • Install Customer Service Unit (CSU)
      • Line Compensation/Equalization
    • Connect Coupled Bonding Conductor (CBC)
  • INSTALL EQUIPMENT ROOM STATION CABLING
    • Connect Building Wiring to SIP
      • Modular Plug Termination
      • 4-Pair Cable Terminations
    • Connect Cabinets to SIP
      • Prepare Carrier Loading Labels
      • Modify Octopus Cables if Required
      • Make SIP Connection for CPU/Memory
      • Make SIP Connections to Cabinet for 7300H Series Terminals
      • Make SIP Connections to Cabinet for MET Sets
      • Make SIP Connections to Cabinet for Single-Line Sets
      • Make SIP Connections for Data Terminals and Computers
      • Make SIP Connections to Cabinet for ATL Cordless Telephones
      • Perform SIP Housekeeping
  • INSTALL EMERGENCY TRANSFER UNITS (ETUs)
    • Make Emergency Transfer Connections
    • Install Ground-Start Key
  • INSTALL ATTENDANT CONSOLE
  • INSTALL TERMINALS
    • Label Terminals
    • Stand-Alone Voice Terminals
    • Stand-Alone Remotely Powered Voice Terminals
    • Single-Line and 7300H Series Voice Terminals With Associated ADUs
    • ATL Cordless Telephone
    • Off-Premises Stations (TN742, TN746B in R3V2)
    • Out-of-Building Voice Terminals (TN742, TN746B in R3V2)
    • Out-of-Building Voice Terminals (ZTN79)
    • Off-Premises-DS1 Interface
    • Stand-Alone Data Terminals
      • ADU Connections
      • MADU Connections
  • INSTALL CUSTOMER’S SAT
    • Nonswitched Connection of Equipment Plugged Into System AC Outlet
    • Nonswitched Connection of Equipment
    • On-Premises Digital Switched Connection
    • Off-Premises Nonswitched Connection
    • Off-Premises Switched Connection
  • INSTALL CUSTOMER’S DTU
  • INSTALL STATION MESSAGE DIGITAL RECORDING (SMDR) EQUIPMENT
  • INSTALL STARLAN NETWORK INTERFACE
    • Shared System 25 Voice/STARLAN NETWORK Data Connections
      • Single-Line Voice Terminals
      • 73001H Series Voice Terminals
  • INSTALL MUSIC-ON-HOLD INTERFACE
    • FCC-Registered Music Source Interface
    • Non-FCC Registered Music Source Interface
  • INSTALL EXTERNAL ALERTS
  • INSTALL RECORDED DELAY ANNOUNCEMENT
  • INSTALL DICTATION SYSTEM INTERFACE
  • INSTALL PAGING SYSTEM INTERFACE
    • Direct Connection to TN763 Auxiliary Trunk CP
    • Connection to TN763 Auxiliary Trunk CP (278A Adapter Required)
    • Connection to ZTN76 or ZTN77 CP
• 3. SYSTEM TESTS
  • TEST OUTGOING TRUNKS
  • TEST DS1 INTERFACE
  • TEST INCOMING DID TRUNKS
  • TEST INCOMING TIE TRUNKS
  • TEST 7300H SERIES VOICE TERMINALS
  • TEST SINGLE-LINE VOICE TERMINALS
  • TEST ATL CORDLESS TELEPHONE
  • TEST DIAL ACCESS CODES
  • TEST SYSTEM FEATURES
    • ARS and SMDR Tests
    • DGC Test
    • System Speed Dialing Test
    • PDC Login Test
    • Call Coverage Test
  • TEST ATTENDANT CONSOLE
  • TEST SELECTOR CONSOLE
  • TEST DATA TERMINAL DIALING FEATURE
  • MAKE POOLED MODEM TEST CALL
  • TEST TRANSFER TO DATA
  • TEST EXTERNAL ALERT (NIGHT SERVICE)
  • TEST DICTATION SYSTEM ACCESS
  • TEST PAGING INTERFACE
  • TEST MUSIC-ON-HOLD
  • TEST EMERGENCY TRANSFER
  • TEST TOUCH-TONE RECEIVERS
• 4. MAINTENANCE
  • EQUIPMENT NEEDED
    • Precautions
  • GENERAL MAINTENANCE INFORMATION
    • System Errors and Alarms
    • Emergency Transfer
    • Circuit Pack LEDs
    • Attendant Console LED
    • Power Supply LED
    • Switches and Test Points
    • System Administration Terminal
    • Remote Initialization and Maintenance (RIM) Service
  • MAINTENANCE STRATEGY
    • Total System Failures
    • Port Problems
    • Common Control Problems
    • Station, Wiring, and Trunk Problems
    • Automatic Maintenance Tests
    • Maintenance Failure
  • USING THE DIGITAL TAPE UNIT
    • Setting Up the DTU
    • Saving Translations
    • Verifying Translations
    • Restoring Translations
  • ROUTINE MAINTENANCE
    • Reseating and Replacing Circuit Packs
    • Removing and Restoring Power
    • Restarting the System
  • ERROR LOG
    • Accessing the Error Log From the SAT
  • ERROR MESSAGES
    • Clearing System-Detected Troubles
    • Complete System Failure
    • Common Control Trouble
    • Circuit Pack Trouble
    • Frontplane Ribbon Connector Trouble (Release 1 Only)
    • Power Supply Trouble
      • Power Supply Protection
      • Power Supply Replacement
    • Fan Assembly Trouble
    • Overheating Trouble
    • Backplane and Cabinet Trouble
    • Emergency Transfer Unit Trouble
  • CLEARING USER-DETECTED TROUBLES
    • Administration Equipment Troubles
    • Time-Keeping Troubles
    • Voice Terminal and Wiring Troubles
    • Voice Transmission Troubles
    • 7300H Series Terminal Troubles
    • Virtual Facilities Troubles
    • Trunk Troubles
      • Outgoing Trunk Problems
      • Incoming Trunk Problems
      • Error Log Interpretation: Loop-Start Trunks
      • Error Log Interpretation: Ground-Start Trunks
      • DID Trunks Troubles
    • Switched Loop Attendant Console Troubles
    • Special Port Circuit Options for Stations and Trunks
    • Data Line Troubles
    • Multiple Troubles or Trouble That Cannot Be Diagnosed
• 5. REFERENCES
• 6. ABBREVIATIONS AND ACRONYMS
• A. System Wiring Tables
  • Connector Pin Assignments
  • System 25 Building Wiring
• B. Parts Listing
• C. System Additions or Changes
  • Evaluate Cabinet Unit Power Load
  • Add Circuit Pack
    • Add Cabling
    • Set Option Switches on TN760B CP
  • Replace Circuit Pack
  • Add Cabinet
  • Add Terminal
  • Add Trunk
  • Add Trunk—DS1 Interface
  • Replace Voice-Only Terminal With Terminal Voice/Data
  • Add Pooled Modem Circuit Pack
  • Add Auxiliary Equipment
• D. System Upgrades
• E. Administration Codes and Data
  • Default Dial Code Assignments
• F. Administration Error Messages
• GLOSSARY
• INDEX