Rockwell Automation 1734-AENT POINT I/O EtherNet/IP Adapter Module - Manual (Page 25)

9 Publication 1734-UM011D-EN-P - May 2011
Chapter
2
Install the Adapter
What This Chapter Contains
This chapter describes how to physically install the adapter on the DIN rail
and connect it to the EtherNet/IP network. The following table lists where to
find specific information.
Identify Adapter
Components
Use the figure to identify the external features of the adapter.
Topic Page
Identify Adapter Components 9
Mount the Adapter on a DIN Rail Before Installing
Modules
10
Mount or Replace the Adapter to an Existing System 11
Wire Your Adapter 12
Mounting Dimensions 13
ATTENTION
You must use series C POINT I/O modules with the 1734-AENT
adapter. Series A or B POINT I/O modules will not work with
this adapter.
Safety end cap
LED indicators
Node address
thumbwheel
EtherNet
network
RJ45
connector
DIN rail
locking screw
(orange)
RTB
removable
handle
Removable Terminal
Block (RTB)
31533-M