JLG E300 Service Manual - Manual (Page 118)

SECTION 4 - BOOM & PLATFORM
4-20 – JLG Lift – 3121253
4. Pull the moving end out over the track so that the
new connection is positioned in the curve of the
powertrack. In this position the round half-shears will
rotate into the peanut cut outs.
5. The parts shown below will be used to connect the
new link to the powertrack.
6. Push pin thru center hole then slide washer on pin.
7. Install the snap ring in the groove on the pin. Repeat
the pin installation steps for all center holes that
have the rivets removed.