Replacing moving end brackets, Replacing moving end brackets -24 – JLG E300 Service Manual User Manual
Page 122
Advertising
SECTION 4 - BOOM & PLATFORM
4-24
– JLG Lift –
3121253
3. Take the new bracket and install bracket center pin
and snap ring. Repeat on the other bracket if replac-
ing it as well.
NOTE: When installing snap rings make sure they are
seated in pin groove and closed properly.
Replacing Moving End Brackets
1. Remove existing pins and center rivet. Remove the
rivet the same way as shown in the link removal
instructions. Repeat on other bracket if replacing it
as well.
CLOSED SNAP RING
SNAP RING NOT
CLOSED PROPERLY
Advertising