JLG E300 Service Manual - Manual (Page 205)

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3121253 – JLG Lift – 7-5
AMP Mate-N-Lok
Follow the installation instructions.
DIN Connectors
This connector is typically used on hydraulic valves. Fol-
low the installation instructions.
Exclusions
A limited number of connectors do not benefit from dielec-
tric grease, or may be permanently damaged by applica-
tion. Dielectric grease may not be required in properly
sealed enclosures.
Figure 7-6. Use of Seal Plugs