JLG E300 Service Manual - Manual (Page 207)

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3121253 – JLG Lift – 7-7
7.4 AMP CONNECTOR
Assembly
Check to be sure the wedge lock is in the open, or as-
shipped, position (See Figure 7-7.). Proceed as follows:
1. To insert a contact, push it straight into the appropri-
ate circuit cavity as far as it will go (See Figure 7-9.).
2. Pull back on the contact wire with a force of 1 or 2
lbs. to be sure the retention fingers are holding the
contact (See Figure 7-9.).
Figure 7-7. Connector Assembly Figure 1
Figure 7-8. AMP Connector