Machine inspection, 3 operation, General – JLG R6 User Manual

Page 13: Machine inspection -3, Operation -3, General -3

Advertising
background image

SECTION 1 - SAFETY PRECAUTIONS

3121684

– JLG Lift –

1-3

• Check the work area for hazardous locations. Do not oper-

ate the machine in hazardous environments unless
approved for that purpose by JLG.

• Ensure that the ground conditions are adequate to support

the maximum tire load indicated on the tire load decals
located on the chassis adjacent to each wheel.

• This machine can be operated in nominal ambient temper-

atures of 0

o

F to 104

o

F (-20

o

C to 40

o

C). Consult JLG to opti-

mize operation outside of this temperature range.

Machine Inspection

• Do not operate this machine until the inspections and func-

tional checks have been performed as specified in Section 2
of this manual.

• Do not operate this machine until it has been serviced and

maintained according to the maintenance and inspection
requirements as specified in the machine’s Service and
Maintenance Manual.

• Ensure all safety devices are operating properly. Modifica-

tion of these devices is a safety violation.

MODIFICATION OR ALTERATION OF AN AERIAL WORK PLATFORM SHALL BE
MADE ONLY WITH PRIOR WRITTEN PERMISSION FROM THE MANUFACTURER.

• Do not operate any machine on which the safety or instruc-

tion placards or decals are missing or illegible.

• Check the machine for modifications to original compo-

nents. Ensure that any modifications have been approved
by JLG.

• Avoid accumulation of debris on platform deck. Keep mud,

oil, grease, and other slippery substances from footwear
and platform deck.

1.3

OPERATION

General

• Machine operation requires your full attention. Bring the

machine to a full stop before using any device, i.e. cell
phones, two-way radios, etc. that will distract your attention
from safely operating the machine.

• Do not use the machine for any purpose other than posi-

tioning personnel, their tools, and equipment.

• Before operation, the user must be familiar with the

machine capabilities and operating characteristics of all
functions.

• Never operate a malfunctioning machine. If a malfunction

occurs, shut down the machine. Remove the unit from ser-
vice and notify the proper authorities.

Advertising