1 power-up, 1 power-up -16, 0 help comments – JLG R6 User Manual

Page 76

Advertising
background image

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE

5-16

– JLG Lift –

3121684

005

DRIVE & LIFT UP PREVENTED - TILTED &
ELEVATED

Driving is not possible since the platform is
elevated and the chassis is not level.

• Check that the machine is tilted. If so, lower the platform and reposition the

machine to a level surface.

• Fully stow the platform.
• Check that the tilt sensor is securely mounted.
• Check that the pothole protection switches are securely mounted and prop-

erly adjusted.

• Check that the elevation angle sensor is securely mounted and properly

adjusted.

Refer problem to a qualified JLG mechanic.

007

DRIVING AT CUTBACK - POTHOLE STILL
ENGAGED

While stowed, drive speed is reduced since the
control system detected that the pothole pro-
tection mechanism failed to retract.

• Check for obstructions around the pot-hole protection mechanisms.
• Check that the PHP switches are securely mounted and adjusted.

Refer problem to a qualified JLG mechanic.

008

FUNCTIONS LOCKED OUT - SYSTEM
POWERED DOWN

After 2 hours without activity, the control sys-
tem enters a low-power state to preserve bat-
tery charge.

• Normal operation should resume after power is cycled off then back on.
• Check batteries charge, condition, etc.

Refer problem to a qualified JLG mechanic.

0-0 Help Comments

DTC

FAULT MESSAGE

DESCRIPTION

CHECK

2-1 Power-Up

DTC

FAULT MESSAGE

DESCRIPTION

CHECK

211

POWER CYCLE

This help message is issued at each power
cycle. Displays on the analyzer only.

Normal operation. No check necessary.

Advertising