JLG R6 - Manual (Page 45)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121684 – JLG Lift – 3-13
Platform Emergency Stop Switch - (Item 8 - Figure 3-7.)
NOTE: Both the ground and platform emergency stop buttons
must be set to ON in order to operate the machine.
When power is directed to the platform from the ground control
station, the platform emergency stop switch is turned on by
pulling the switch out (on), and is turned off by pushing the
switch in (off ). The two-position, red, mushroom-shaped emer-
gency stop switch functions to provide power to the platform
control station and also to turn off power to machine functions
in the event of an emergency.
Lift/Drive Select - (Item 10 - Figure 3-7.)
NOTE: When selecting between the Lift and Drive functions the
joystick control must be returned to the neutral position
for approximately 1/2 second before the function change
is operable.
This toggle switch is used to select operation of either the drive
or lift function. After selecting a function, the joystick controller
must be moved in the proper direction in order to activate that
function. Only change the function selected, with the joystick in
the neutral position. Otherwise, the function selected will not
change until the joystick is returned to the neutral position.
Forward/Reverse/Lift/Lower Direction
Decal
- (Item 4 - Figure 3-7.)
This decal indicates the proper direction to
mount the platform control box, the black
arrow must point to the front of the machine.
The black/white arrow also indicates the
direction to move the joystick control per the
lift/drive selector switch decal for the lift and drive select func-
tions.
1001132362 B