JLG R6 - Manual (Page 40)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-8 – JLG Lift – 3121684
NOTE: When more than one DTC exists, each DTC will be dis-
played on the LCD for 3 seconds before changing to the
next DTC. Once the last active DTC is displayed, the display
will recycle indefinitely until the DTC’s are corrected.
For DTC’s and descriptions, refer to Section 5.9.
Also located on the MDI are Battery Discharge Indicators
(BDI)
(items 4 thru 7). (4) GREEN LEDs indicate the level of
charge (voltage) remaining in the batteries.
NOTE: When the battery voltage is low and will need a charge
soon, the
LED (item 4) in the 0-25% range "red area" will
flash.
Under normal operating conditions the BDI’s and hour-meter
will be displayed. When a DTC exists (other than 00x DTC’s) the
BDI LEDs and hour-meter will not be displayed. Also when plat-
form is elevated and the machine is being driven the creep
mode (turtle) is displayed.
Overload Indicator - (Item 5 - Figure 3-3.)
Overload Indicator - Indicates the platform has been over-
loaded. An audible alarm will also signal when the platform is
overloaded.
NOTE: If the Overload Indicator is illuminated, all functions will
be prevented from the platform controls. Reduce the
weight in the platform to not exceed the rated workload
indicated on the capacity decal, or fully lower the plat-
form using the ground controls, or manual descent.
Figure 3-4. MDI Indicator
1. Hour meter, Wrench, Creep Icon Indi-
cators
2. Hour meter/DTC Code Display
3. System Fault LED Indicator (RED LED)
4. 0-25% Charge Indicator (RED AREA)
5. 50% Charge Indicator (YELLOW AREA)
6. 75% Charge Indicator (GREEN AREA)
7. 100% Charge Indicator (GREEN AREA)
1
2
3
7
6
5
4