JLG 10MSP Operator Manual - Manual (Page 29)

SECTION 3 - MACHINE OPERATION
3121227 – JLG Lift – 3-1
SECTION 3. MACHINE OPERATION
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to under-
stand control function and operation.
3.2 MACHINE DESCRIPTION
The JLG 10MSP Lift is an electric powered self-propelled machine
with an aerial work platform mounted to an elevating mast mecha-
nism. The personnel lift’s intended purpose is to provide person-
nel access to areas above ground level.
The primary control console is located in the platform. From the
Platform Control Console the operator can drive the machine and
raise or lower the platform.
The machine is rear wheel drive and provide steering with free-
wheeling front caster wheels.
The controls of the programmable Ground Control Station are to
be used during machine power-up, maintenance, function checks,
or in case of emergency, should the operator in the platform be
unable to lower the platform.
Vibrations emitted by these machines are not hazardous to an
operator working in the platform.
The continuous A-Weighted sound pressure level at the work plat-
form is less than 70db (A).