JLG 10MSP Operator Manual - Manual (Page 42)

SECTION 3 - MACHINE OPERATION
3-14 – JLG Lift – 3121227
In the LCD Display Symbols (previous illustration - item-2), the
Function Display or Function Disabled Indicators will vary as
shown following: Tilt Alarm Warning
The Ground Control Station LCD screen flashes a fault code
and gives an audible warning. The LEDs on the platform control
console also flash during the tilt warning. See Table 3-2 on
page 3-15
THE GROUND CONTROL STATION CONTAINS A 1.5 DEGREE TILT
ALARM, IF THE TILT ALARM HAS BEEN ACTIVATED, THE PLATFORM
WILL NOT ELEVATE. ALSO IF THE TILT ALARM HAS BEEN ACTIVATED
WHEN THE PLATFORM IS ELEVATED, THE DRIVE AND LIFT UP FUNC-
TIONS WILL BE DISABLED UNTIL THE PLATFORM IS COMPLETELY
LOWERED AND DRIVEN OFF THE TILT CONDITION.
LCD Display Fault Conditions
Table 3-2 following shows common LCD display Fault indicators
which may occur during operation and are usually caused by
either an error in machine operation or a work area condition.
These fault conditions can usually be corrected by the operator
and do not require a qualified mechanic to repair:
AFTER A FAULT CONDITION IS CORRECTED THE MACHINE POWER
MAY NEED TO BE RECYCLED TO RESET THE GROUND CONTROL STA-
TION.
DRIVE Disabled
LIFT UP Disabled
LIFT DOWN Disabled
Both LIFT UP and LIFT DOWN Disabled
Drive Speed Cut-Back (Turtle) Mode Engaged
(When Platform is Elevated)
Battery Charger (AC) Plugged In