JLG 10MSP Operator Manual - Manual (Page 63)

SECTION 3 - MACHINE OPERATION
3121227 – JLG Lift – 3-35
Hanger Accessory - Pre-Start Inspection
Prior to use of the hanger accessory, check the following;
• Hanger arm mounting is secure to the platform railing, no
missing or damaged fasteners.
• The hanger arm lock pin is in place and secure.
Loading and Transporting an Item using the
Hanger Accessory
Use the following steps as a guide when loading and transporting
an object with the hanger accessory arm.
1. Keep the hanger arm in the stowed position when not in use.
2. When ready to use, pull the lock pin from the stowed position
hole and swing the hanger arm into the carry position. Place
pin in the carry position hole locking the hanger arm in place.
3. Load the object onto the hanger arm and use the hanger arm
strap to secure the object during transport.
4. Be aware of clearance above, below, and around the object
when driving and lifting or lowering the platform.
3.15 RUG CARRIER ACCESSORY - (OPTION)
NOTE: This rug carrier accessory is intended for use in placing
or retrieving rolled/unrolled rugs and other similar stock
stored on racks or shelves above ground level. Use for
any other purpose is not authorized by JLG.
The rug carrier accessory consists of two extendable arms
mounted on the left side of the 10MSP machine. The maximum
combined load carrying capacity for both arms is 50 lb. (23kg).
The carrier arms can be retracted out of the way when not in use.
Pre-Start Inspection
Prior to use of the carrier accessory, check the following;
• The material tray is fully raised and locked in position.
• Carrier arm mounts are secure to the machine, no missing or
damaged fasteners.
• The carrier arms lock pins are in place and secure.