JLG 10MSP Operator Manual - Manual (Page 44)

SECTION 3 - MACHINE OPERATION
3-16 – JLG Lift – 3121227
6 8
Drive Motor Brush Wear Warning
(Counts down 25 hrs. of DRIVE
operation remaining to a 10 sec.
shut down mode) Drive Motor Brushes Require Ser-
vice Replacement -
(See Section 5.7 on page 5-16 for
further Instructions)
13 6
Traction Module Over Temperature
(DRIVE Disabled)
Allow Drive System Traction Mod-
ule to Cool Before Operating
(Caused by extreme temperature)
17 7
Ground Control Module Over Tem-
perature (Machine Stopped)
Allow Ground Control Module to
Cool Before Operating -
(Caused by extreme temperature)
32 7
Pump Motor Over Current
(LIFT UP Disabled)
Platform Load Over Capacity
34 —
Aux. #1 - Platform Gate Open or
No Pressure on the Platform Foot-
switch Close Platform Gate or Depress
Platform Footswitch during
machine operation
35 —
Aux. #1 - Platform Footswitch
depressed during Machine Power-
up
Do Not Press on Platform Foot-
switch during Machine Power-Up
NOTE: The fault conditions shown in this table are fault conditions which the Operator may be able to resolve. Should a fault occur which cannot be cor-
rected at the Operator’s level, the problem must be referred to a mechanic qualified to repair this model of JLG Lift. A complete table of Fault Codes
is listed in the TroubleShooting Section of the Service and Maintenance Manual.
Table 3-2. LCD Display - Operating Fault Conditions (Continued)
FAULT
CODE
PLATFORM
LEDs
FLASHING
LCD SYMBOL SCREEN LCD TEXT SCREEN
FAULT DESCRIPTION/
MACHINE CONDITION
TO CORRECT PROBLEM
13 13 00000.0
17 17 00000.0
32 32 00000.0