JLG 10MSP Operator Manual - Manual (Page 32)

SECTION 3 - MACHINE OPERATION
3-4 – JLG Lift – 3121227
3.4 HOOD - (CARRY DECK)
Removal:
1. To remove the hood, loosen the attach screw on the front of
the hood.
2. Lift the hood at the front to clear the rubber sealing gasket on
the base frame and slide the hood forward while lifting up to
completely remove it from the machine.
Installation:
1. Set hood down into the hood gasket on the top of the frame
and slide it rearward. Be certain the rear hold-down bracket
engages the hood support underneath the hood.
2. Tighten the hood attach screw at the front of the hood.
DO NOT ALLOW ANY PERSONNEL TO
RIDE ON THE CARRY DECK HOOD.
Figure 3-3. Carry Deck - Hood Removal.
1. Hood - Carry Deck
2. Attach Screw 3. Rear Hold-Down Bracket -
Located Under Hood - Slides
Under Hood Support
1
3
2