2N VoiceBlue Lite - Manual v2.6 - Manual (Page 54)

Announcement number Default file Designation in configuration programme
MESS1 MESS1 - HELLO.wav Announcement “Good day”
MESS2 MESS2 - ME.wav Announcement “Mobile extension”
MESS3 MESS3 - DIAL.wav Announcement “Dial number”
MESS4 MESS4 - TZ.wav Announcement “Text announcement”
MESS5 MESS5 - AC.wav Announcement “Activated”
MESS6 MESS6 - DC.wav Announcement “Deactivated”
MESS7 MESS7 - HOLD.wav Announcement “Hold on”
MESS8 MESS8 - BACK.wav Announcement “Back”
Tab. 4 - list of announcements of service Mobility extension
The format of the recorded announcements must be
Sampling frequency : 8 kHz
Number of bits in sample 8
Audio encoding method: CCITT A-law
Channels: Mono
Length of recording: Max. 4s
Recording of announcements using terminal and protocol
Xmodem
Recording announcements from PC to VoiceBlue
Run the terminal programme supporting the protocol Xmodem and
use it to connect up with VoiceBlue.
• Using the AT order at!m#=write, where instead of # fill in the
number of the announcement which is meant to be loaded into
VoiceBlue. The value “0” is designated for the announcement
DISA, the numbers of the other announcements are given
in Tab. 4 - list of announcements of service Mobility extension
• . After the insertion of an order you will be called upon to
select an audio file which is to be loaded into VoiceBlue.
• Successful loading is announced by the message
Loading announcements from VoiceBlue to PC
• Run the terminal programme supporting the protocol Xmodem
and use it to connect up with VoiceBlue
44