INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual - Manual (Page 21)

1 - 9
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
1.5 Unpacking and Inspection
1 If the SQM-242 card has not been removed from its packaging, do so now.
2 Carefully examine the card for damage that may have occurred during
shipping. This is especially important if you notice obvious rough handling on
the outside of the container. Immediately report any damage to the carrier and
to INFICON.
3 Do not discard the packing materials until you have taken inventory and have
at least performed successful installation.
4 Take an inventory of your order by referring to your order invoice and the
information contained in
section 1.6 .
5 To install the card, see Chapter 2, Installation .
6 For additional information or technical assistance, contact INFICON, refer to
section 1.3 on page 1-5 .
1.6 Parts and Options Overview
1.6.1 Base Configurations
SQM-242 Card . . . . . . . . . . . . . . . . . . . . .782-SQM-242
SQS-242 Software . . . . . . . . . . . . . . . . . .782-SQS-242, Optional
SAM-242 Card . . . . . . . . . . . . . . . . . . . . .782-SAM-242, Optional
Technical Manual . . . . . . . . . . . . . . . . . . .074-549 on 074-5000-G1 CD
1.6.2 Accessories
Each sensor requires an oscillator kit to interface to the controller:
SQM-242 10' Oscillator Kit . . . . . . . . 782-934-003-10
SQM-242 25' Oscillator Kit . . . . . . . . 782-934-003-25
SQM-242 50' Oscillator Kit . . . . . . . . 782-934-003-50
SQM-242 100' Oscillator Kit . . . . . . . 782-934-003-99
Above kits consist of oscillator 782-900-010, 6 inch BNC oscillator to feedthrough
cable 782-902-011 and BNC controller to oscillator cable 782-902-012-10,
782-902-012-25, 782-902-012-50 or 782-902-012-99. These kits are designed for
use with the standard in-vacuum cables ranging in length from 6 inches (15.2 cm)
to 36 inches (91.4 cm). The 007-044 standard in-vacuum cable supplied with the
front load style sensors are 30.75 inches (78.1 cm) long.