Chapter 5 sqm-242 multi, 1 introduction, Chapter 5 – INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual User Manual
Page 43
5 - 1
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
Chapter 5
SQM-242 Multi
5.1 Introduction
The SQM-242 Multi program extends the capabilities of the SQM-242 CoDep
program to include up to six SQM-242 cards. With the SQM-242 Multi program, you
can monitor up to twenty four sensors and control up to 12 source outputs.
Figure 5-1 SQM-242 Multi Main Dialog Box
On startup, the program displays the firmware revision of each card that is properly
installed. If an SQM-242 is installed, but no revision (e.g., Card 1: 2.00) is
displayed, then consult the card installation section of this manual (refer to
section 2.1, SQM-242 Card Installation, on page 2-1
Operation of the SQM-242 Multi program is very similar to SQM-242 CoDep. Refer
to the previous chapter for descriptions of the parameter settings and readings text
boxes (refer to