INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual - Manual (Page 35)

3 - 7
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
In the sensor grid, the Life column displays the % life remaining for each sensor,
based on the sensor Min/Max values entered in the Setup dialog box.
In the analog input grid, two readings are displayed. Volts shows the measured
voltage on the analog input, while Units displays the reading in the units displayed
on the main dialog box (i.e., CFM). The next section explains how to define analog
input units.
The last column shows the function assigned to each input-output control, setpoint
monitor, or unassigned. If an input is assigned to a control loop, that output is listed.
An input assigned as a setpoint monitor (see the next section) shows Monitor. If
an input is assigned as both a control input and a setpoint monitor, only the control
function is listed. Unassigned inputs show None.
3.6.2 View Menu: Input Setup
The Input Setup dialog box configures each input on the SQM-242 and SAM-242
cards. See
Figure 3-5 .
Inputs are numbered consecutively, starting with Card 1 (Sensors 1 to 4), then
Card 2 (Sensors 5 to 8), etcetera. The SAM-242 analog input card is shown as
Analog 1 to 4.
Figure 3-5 Input Setup Dialog Box