Chapter 4 sqm-242 monitor, 1 introduction, Chapter 4 – INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual User Manual
Page 41
Advertising
4 - 1
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
Chapter 4
SQM-242 Monitor
4.1 Introduction
The SQM-242 Monitor program is a version of SQM-242 CoDep that has been
streamlined for monitor-only applications. With SQM-242 Monitor you enter sensor
Density, Tooling, and Z-Ratio (Z-Factor) parameters, then click Start to begin taking
readings.
Figure 4-1 SQM-242 Monitor Main Dialog Box
Since this is a monitor-only program, there are no settings for output control. The
Setup dialog box contains only monitor-related functions. Simulate mode is not
available because it would provide no additional information.
Figure 4-2 Monitor Setup Dialog Box
Capabilities to save setup parameters and log data to the hard disk are identical to
those of SQM-242 CoDep.
Advertising