INFICON Composer Elite Gas Concentration Monitor - Manual (Page 100)

5 - 34
PN
07
4-
56
6-
P1
B
Composer Elite Operating Manual
12 Heater 2 Current -
Expectations Not Met 0x0000 0800 SC SS Self Clear ACTION(SC): SC shuts off
Heater.
ACTION(CC): CC may
reallocate any power
management resources
assigned to the SC.
NOTE: Does not meet
expectation based on PWM duty
11 Heater 1 Setpoint -
Bad Parameter 0x0000 0400 SC SS Cleared on
read
NOTE: Attempt made to set
parameter above operating
range (>65°C).
10 Heater 2 Setpoint -
Bad Parameter 0x0000 0200 SC SS Cleared on
read
NOTE: Attempt made to set
parameter above operating
range (>68°C).
Table 5-23 System and hardware warnings
Warning
Number
Description Warning Code Set by
CC 1
or SC 2
Sensor
Specific
(SS 3 )
Set/Clear
Trigger
General Notes/Actions
32 Composer Elite
Temperature Outside
Operating Range 0x8000 0000 CC Self clear
31 DeviceNet Installed
but Not Operating 0x4000 0000 CC Self clear NOTE: Indicates that the
DeviceNet module was found
but DeviceNet system is not
currently operating.
30 DeviceNet Failed to
Transmit a Response 0x2000 0000 CC Cleared on
read
NOTE: Failed to transfer
response from CC to ABIC
4
module.
29 Parameters Reset 0x1000 0000 CC Cleared on
read
NOTE: Could be result of
automatic parameter reset due
to compatibility error or from a
manual reset.
28 CC Firmware
Changed 0x0800 0000 CC Cleared on
read
27 Splash Image
Incompatible or Invalid 0x0400 0000 CC Cleared on
read
NOTE: The splash image read is
not compatible with the system
expectations and thus cannot be
displayed.
26 Parameters Upgraded 0x0200 0000 CC Cleared on
read
1 CC = Controller Card, 2 SC = Sensor Card, 3 SS = Specific Sensor, 4 ABIC = Anybus Integrated Circuit,
5 R2= Lorentzian Coefficient of Determination
Table 5-22 System and hardware errors (continued)
Error
Number
Description Error Code Set by
CC1
or SC2
Sensor
Specific
(SS3)
Set/Clear
Trigger
General Notes/Actions
1 CC = Controller Card, 2 SC = Sensor Card, 3 SS = Specific Sensor