Leica Biosystems CM1510-S - Manual (Page 19)

19 Leica CM1510 S – Cryostat
The handwheel and all hardware
items needed to attach it to the cry-
ostat are packed in the accessory
box. The handwheel can be dis-
mounted e.g. for transport through
narrow doors.
• Insert the pin (1) of the handwheel shaft
into the bore (2) of the handwheel.
• Place spring washer (3) onto screw (4) with
the curved surface pointing to the right side
(see also Fig. 6).
• Tighten screw (4) with the size 6 Allen key.
To disassemble, proceed in reverse order.
The protective foam parts between
microtome and compressor MUST be
removed prior to operating the instru-
ment (see Fig. 7)!
Caution! Edges of gilled evaporator
are extremely sharp! High risk of in-
jury!
4.4 Fastening the handwheel
1
2
3
4
Fig. 6
5
Fig. 7
4. Setup
The handwheel is lockable with the handle in
the upper position.