Setup – Leica Biosystems CM1510-S User Manual
Page 21
21
Leica CM1510 S – Cryostat
The temperature controller display first reads the actual temperature of
the cryochamber.
After the instrument mains switch has been switched on, it will
take about 5 seconds until the compressor starts operating.
Bear in mind the required minimum switch-off period!
4.6.1 Mains switch and automatic circuit breaker
The automatic circuit breakers (mains fuses) are also used as mains
switch.
To turn the automatic circuit breaker on, flip it to the upper position. To
disconnect, set the circuit breaker in the lower position.
Fig.
9
•
Turn the automatic circuit breaker on. The instrument is initialized.
•
The factory configuration settings are as follows:
Real time:
00:00
Defrost time:
23:50 (adjustable, see chapter 5.2)
Chamber cooling:
on
(temperature indication)
4.
Setup