Lenze ETC Motion Control - Manual (Page 256)

Interface PLC <˘> NC operating system
Definitions
Data block 1
5
5.1
5.1.2
l
256 EDSTCXN EN 2.0
Data word Name Direction Type of signal
042.00−043.15 Offset of the "fast inputs" PLC
→
NC static
Use the two data words to position the 2 masks "Enable fast inputs" to any
place in the process image.
Effect in the NC: The corresponding inputs are made available to the NC as
Q bits.
Example: see "Enable of fast inputs"
Data word Name Direction Type of signal
044.00−045.15 Offset of the "fast outputs" PLC
→
NC static
Use the two data words to position the 2 masks "Enable fast outputs" anyw-
here in the process image. By default, the enable of the "fast outputs" affects
the 1st digital I/O card (EC−IO).
Effect in the NC: The Q bits are transferred to the corresponding outputs.
Data word Name Direction Type of signal
080 General override for axes PLC
→
NC static
081 Override for spindle speed PLC
→
NC static
082 Override for oscillation speed PLC → NC static
083 Override for PLC axes (Target
position approach) PLC
→
NC static
Definition of a signed evaluation factor for the currently valid traversing
speed. The specification is made in steps of 0.1 %.
Effect in the NC: The selected value is used as factor for evaluating the cur-
rently programmed maximum speed by the rough interpolator.
The override is effective in manual as well as automatic operation. It can be
inhibited by M functions within a program (M48/M49 override on/off).