Lenze ETC Motion Control - Manual (Page 73)

Getting started
Testing CNC and PLC program
2
2.13
l
73 EDSTCXN EN 2.0
1. Start the ETC−MMI via <Start> W Programs W Lenze W ETC
In the ETC−MMI window, press <F11> (program).
The MMI window opens in the "Programming" operating mode. It shows
the text editor for the CNC program.
2. Press <F8> (Graphics) and afterwards <F7>(Graphics on/off).
The window is split. The text editor is displayed on the left, the display
field for the graph (graphic area) on the right.
3. Press <F2> (Open program).
4. Select the CNC program (e.g. test.din) and press <Enter>
5. Press <F7> (Program to NC).
6. Select the CNC program (e.g. test.din) and press <Enter>
The CNC program is transferred to the control system ( ¶ 49).
7. Press <S1> (Start).
The drives start and the profile of the rectangle are executed ( ¶ 49).
The drawn straight line from the zero point (0/0) to the starting point
(10/10) is now executed when the drive is also in the zero point.
Otherwise, the control system traverses the drives on a straight line from
the current point to the starting point.
8. Change the material speed to a small value (e.g. 1 %). For this purpose,
click <S7>(Override −).
When the PLC and CNC programs are loaded correctly, a marker follows
the circular profile. The output "Tool down" is set and reset according to
the called M−function.
ETCN035
9. To stop the drives, press <S2> (Stop).
Start CNC program