Lenze ETC Motion Control - Manual (Page 84)

Getting started
Updating the firmware of the ETCHx in the "Standalone" operating mode
Querying the version of the firmware
2
2.16
2.16.2
l
84 EDSTCXN EN 2.0
2.16.2 Querying the version of the firmware
1. When the prompt ">" of the boot monitor is displayed, enter the
command ver.
The version of the firmware is queried and displayed.
ETCN005
ETCN006
2.16.3 Updating the firmware
Initial state: The communication between PC and ETC has been established
and the monitor interface has been activated (
¶ 21).
1. To transfer the current firmware to the ETC, activate the menu item
Transfer W Send File in the HyperTerminal.
ETCM021
2. Specify the path to the firmware file and select the protocol "Zmodem
mit Wiederherstellung" ("Zmodem with Crash Recovery").
Variant "with ETC−MMI"
Variant "Standalone"