Lenze ETC Motion Control - Manual (Page 75)

Getting started
PLC keys in the ETC−MMI
Labelling of the PLC keys in the ETC−MMI
2
2.14
2.14.1
l
75 EDSTCXN EN 2.0
2.14 PLC keys in the ETC−MMI
In the "PLC KEYS" operating mode, it is possible to start manual functions in
the PLC from the ETC−MMI. For this purpose, 6 menu levels are available. This
corresponds to 42 function keys.
In this example, the following assignments are to be made to three PLC keys:
F1: System on/off
F4: Lower tool
F5: Lift tool
2.14.1 Labelling of the PLC keys in the ETC−MMI
The labelling of the PLC KEYS is realised in the language−dependent file
lenze.txt.
ETCN037
These texts are then assigned to the keys by the configuration file
delphmmi.ini :
ETCN038